Operating instructions

W Calibration/adjustment (depending on the menu setting)
*)
Z Internal calibration/adjustment
**)
f0_ Function key (F)
f1_ Function key (CAL)
s3_ C key
x0_ Perform internal calibration
**)
x1_ Print balance/scale model
x2_ Print weighing cell serial number
x3_ Print software version
*)
may be inaccessible on verified balances/scales
**)
only on models with built-in motorized calibration weight
Functionality mapping
"HOST" settings: Sartorius printer settings:
"SND.OFF" not applicable
"SND.STB" manually print with stability
"SND.ALL" manually print without stability
"SND.CONT" automatically print without stability
"SND.AUTO" similar applicable to automatically print
when load is changed
"BAUD" – Baud rate RS232C
1)
This menu topic allows you to match the data transmission to different serial RS232C receivers. The baud rate
(data transfer rate) determines the speed of transmission via the serial interface. For problem-free data trans
mission the sending and receiving devices must be set at the same value.
The following settings are available:
600 bd, 1200 bd, 2400 bd, 4800 bd, 9600 bd, 19200 and 38400 bd. (default: 9600 bd)
Note:
●
Not visible for 2nd display.
●
Each device has separate settings.
"BIT.PAR." – Bit/Parity RS232C
1)
At this menu topic you can set the character format for the attached RS232C serial peripheral device.
"8/NO" 8 data bits/no parity (Factory setting)
"7/NO" 7 data bits/no parity
"7/MARK" 7 data bits/mark parity
"7/SPACE" 7 data bits/space parity
"7/EVEN" 7 data bits/even parity
"7/ODD" 7 data bits/odd parity
Note:
●
Not visible for 2nd display.
●
Each device has separate settings.
35
The Menu