Operating instructions

"LN.FEED" – Options for Complete the Printout of individual values

This menu topic allows you to specify the number of blank lines to complete the printout (line feed) for every

individual weighing result (after pressing « ») .

Note: This menu topic is only available if “PRINTER” setting was selected.

"0" Possible numbers of blank lines: 0 to 99 (Factory setting = 0)

"ZERO.PRT" – Options for “PRT.AUTO”

This menu topic allows you to specify the auto print function “PRT.AUTO” for printing zero "YES" or "NO".

"OFF" Zero is not be printed (Zero +/- 3d) (Factory setting)

"ON" Zero is always printed

Note: This menu topic is only available if "PRT.AUTO" fuction of the "PRINTER" or "PC-DIR." was selected.

"COM.SET" – Options for the Data Communication Format (RS232C)(“HOST”)

This menu topic allows you to set the data format depending on which peripheral device is connected.

Note: This menu topic is only available if “HOST” setting was selected.

"MT-SICS" The MT-SICS data transfer formats is used. (Factory setting)

For more information see section “MT-SICS Interface Commands

and Functions”.

"MT-PM" The following PM balance commands are supported:

S Send value

SI Send immediate value

SIR Send value and repeat

SR Send next value and repeat

SNR Send immediate value and repeat

T Tare

TI Tare immediately

B Base (Negative values are limited up to the current tare

values)

MI Modify ambient vibration

MZ Modify Auto Zero

M Modified settings reset

ID Identify

CA Calibrate

D Display (only symbol N and G available)

"SART" The following Sartorius commands are supported:

K Ambient conditions: very stable

L Ambient conditions: stable

M Ambient conditions: unstable

N Ambient conditions: very unstable

O Block keys

P Print key (print, auto print; activate or block)

Q Acoustic signal

R Unblock keys

S Restart/self-test

T Tare key

The Menu