Operating instructions

"HOST" Connection to a PC, Barcode Reader etc.: the balance can send
data to the PC and receive commands or data from the PC.
Note: The balance sends the complete MT-SICS answer to the PC
(see chapter "MT-SICS Interface Commands and Functions".
"SND.OFF" Send mode switched off.(Factory setting)
"SND.STB" If the « » key is pressed, the next stable weight value will be
sent.
"SND.CONT" All weight value updates will be sent regardless of stability, with
out pressing the «
» key.
"SND.AUTO" Every stable weight value will be sent, without pressing the « »
key.
"SND.ALL" If the « » key is pressed, the weight value will be sent regard
less of stability.
"2.DISP" Connection of an optional auxiliary display unit.
Note: The transmission parameters cannot be selected. Settings
are automatically set.
Attention: If you select 2nd Display "2.DISP", first make sure that
no other device is connected at COM1 as an auxiliary display.
Other devices could be damaged because of the voltage on con
nector Pin 9. Necessary for powering the display (see Chapter
"Interface Specification").
"HEADER" – Options for the Printout Header of individual values
This menu topic allows you to specify the information that is to be printed at the top of the printout for every
individual weighing results (after pressing « »).
Note: This menu topic is only available if “PRINTER” setting was selected.
"NO" The header is not be printed (Factory setting)
"DAT/TIM" Date and time are printed
"D/T/BAL" Date, time and balance information (Balance type, SNR, Balance
ID) are printed.
Note: Balance ID only if set.
"SINGLE" – Options for Printing out the Result of individual values
This menu topic allows you to specify the information that is to be printed for every individual weighing result
(after pressing « »).
Note: This menu topic is only available if “PRINTER” setting was selected.
"NET" The value of the Net weight from the current weighing is printed
(Factory setting)
"G/T/N" The values of the Gross weight, the Tare weight and the Net
weight are printed
"SIGN.L" – Options for the Printout Footer for Signature Line of individual values
This menu topic allows you to set a footer for signature at the bottom of the printout for every individual weigh
ing result (after pressing « »).
Note: This menu topic is only available if “PRINTER” setting was selected.
"OFF" The signature footer is not be printed. (Factory setting)
"ON" The signature footer is printed
33The Menu