Operating instructions

"B.L. OFF" Backlight is always off.

"B.L. 30" " Automatic switch-off after 30 seconds inactivity.

"B.L. 1' " Automatic switch-off after 1 minute inactivity.

"B.L. 2' " Automatic switch-off after 2 minutes inactivity.

"B.L. 5' " Automatic switch-off after 5 minutes inactivity.

"A.ZERO" – Automatic Zero Setting

This menu topic allows you to switch the automatic zero setting on or off.

“ON“ "A.ZERO" switched on (factory setting). The automatic zero set

ting continuously corrects possible variations in the zero point

that might be caused through small amounts of contamination

on the weighing pan.

"OFF" "A.ZERO" switched off. The zero point is not automatically cor

rected. This setting is advantageous for special applications (e.g.

evaporation measurements).

Note: With approved balances, this setting is not available (only available in selected countries).

"ZERO.RNG" – Zero Range

This menu topic allows you to set a zero limit for the «

» key. Up to and including this limit the

« » key will execute a zero. Above this limit the « » key will execute a tare.

"21g" To set the upper limit of the zeroing range as weight in the defini

tion unit of the balance.

(Factory setting: 0.5% of weighing range)

Note: With approved balances, this setting is not available and

fixed to 3e (only available in selected countries).

Note: A reset of the balance will not change this setting.

"ASSIGN:F" – Assign Application Key F

At this menu topic you can assign an application to the «F» key. The following applications are available

(depending on the model):

"COUNT" Piece counting (Factory setting)

"PERCENT" Percent weighing

"CHECK" Checkweighing

"STAT" Statistics

"FORMULA" Formulation / Net-Total

"TOTAL" Totaling

"DYNAMIC" Dynamic weighing

"FACTOR.M" Multiplication factor

"FACTOR.D" Division factor

"DENSITY" Density

"R.TEST" Routine test

"DIAGNOS." – Diagnostics Application

At this menu topic you can start a diagnostic application. For more information see chapter application "Diag

nostics".

The following diagnostics are available:

The Menu