Operating instructions

Note: A reset of the balance will not change this setting.
"UNIT 1" – Weight Unit 1
Depending on requirements, the balance can operate with the following units (depending on the model)
●
Only those weight units allowed by the appropriate national legislation are selectable.
●
With approved balances, this menu topic has a fixed setting and cannot be changed.
●
Conversion table for weight units see chapter Appendix.
Units:
g
1)
Gram dwt Pennyweight
kg
2)
Kilogram mom Momme
mg
3)
Milligram msg Mesghal
ct Carat tlh Tael Hong Kong
lb Pound tls
4)
Tael Singapore
oz Ounce (avdp) tlt Tael Taiwan
ozt Ounce (troy) tola Tola
GN Grain baht Baht
1)
factory setting
2)
not with 0.1 mg and 1 mg balances
3)
with 0.1 mg and 1 mg balances
4)
the Malaysian tael has the same value
"UNIT 2" – Weight Unit 2
If it is required to show the weighing results in weighing mode in an additional unit, the desired second weight
unit can be selected in this menu topic (depending on the model). Units see "UNIT 1".
Note: Only those weight units allowed by the appropriate national legislation are selectable.
"KEY.BEEP" – Key Beep
This menu topic allows you to select the volume of the key beep. The according key beep is emitted during the
setting.
"MED" Medium level (Factory setting)
"HIGH" High level
"OFF" Beep switched off
"LOW" Low level
"STB.BEEP" – Stability Beep
If the unstable symbol disappears, the stability beep becomes active. This menu topic allows you to preselect
the volume of the stability beep.
"LOW" Low level (Factory setting)
"MED" Medium level
"HIGH" High level
"OFF" Beep switched off
28
The Menu