Operating instructions

5.2 Performing a Simple Weighing

1250

1182

a) Press « » to zero the balance.

Note: If your balance is not in the weighing mode, first press and

hold the « » key until “WEIGH“ appears in the display. Release

the key. Your balance is in the weighing mode.

b) Place weighing sample on the weighing pan.

c) Wait until the instability detector "

" disappears and the stability

beep sounds.

d) Read the result.

5.3 Zero Setting / Taring

121

Zero setting

a) Unload the balance.

b) Press « » to set the balance to zero. All weight values are

measured in relation to this zero point (see menu topic

"ZERO.RNG").

Note: Use the «

» zeroing key before you start with a weigh

ing.

121

Net

Taring

If you are working with a weighing container, first set the balance to

zero.

a) Place empty container on the balance. The weight is displayed.

b) Press « » to tare the balance.

"0.00 g" and "Net" appears in the display. "Net" indicates that all

weight values displayed are net values.

Note:

●

If the container is removed from the balance, the tare weight will be

shown as a negative value.

●

The tare weight remains stored until the « » key is

pressed again or the balance is switched off.

5.4 Switching Weight Units

0.78

The « » key can be used at any time to toggle between weight unit

"UNIT 1","RECALL" value (if selected), weight unit "UNIT 2" (if different

from weight unit 2) and the application unit (if any).

Weighing Made Simple