Operating instructions

battery fully When the balance is operating on its batteries, the battery symbol in
the display lights up. The number of segments that are lit is an indica
tor of battery condition (3 = fully charged, 0 = discharged). When the
batteries are almost completely discharged, the battery symbol flashes.
2/3 full
1/3 full
battery empty
Inserting / Replacing Batteries
The balance must be disconnected from the power supply when carrying out all setup and
mounting work.
●
Make sure that the balance is off before removing or inserting batteries.
●
Do not place the balance on the pan support location bolt.
●
Battery Warnings: Read and follow all warnings and instructions supplied by the battery
manufacturer.
●
Do not mix different types or brands of batteries. Performance of batteries can vary very
greatly depending on the manufacturer.
●
If you don't operate the balance with batteries for an extended period, it is recommended
to remove the batteries from the balance.
●
Batteries must be disposed of in an environmentally responsible manner. No attempt
must be made to incinerate or disassemble item.
Your balance uses 8 standard AA (LR6) batteries (alkaline batteries preferred)
a) Remove weighing pan, pan support and draft shield element or
draft shield "100 mm" if present.
b) Turn the balance carefully on its side.
c) Open and remove the battery-chamber cover.
d) Insert / replace the batteries with the correct polarity as shown in
the battery holder.
e) Insert and close the battery-chamber cover.
f) Turn the balance carefully to its normal position.
g) Reinstall all components in the reverse order.
4.5 Transporting the Balance
Switch off the balance and remove the power cable and any interface cable from the balance. Refer to the notes
in Section "Selecting the location" regarding the choice of an optimal location.
18
Setting up the Balance