Operating instructions

Balances with 4 leveling feet
a) First turn the two rear leveling feet all the way in.
b) Adjust the two front leveling feet as previously described.
c) Turn the rear leveling feet down onto the surface for extra stabiliz
ing safety, so the balance cannot tilt over under eccentric loads.
4.4 Power Supply
Allow your balance to warm up for 30 minutes (0.1 mg models 60 minutes) to enable it
to adapt itself to the ambient conditions.
4.4.1 AC Operation
Your balance is supplied with an country-specific AC adapter or with a country-specific power cable. The power
supply is suitable for all line voltages in the range: 100 - 240 VAC, 50/60 Hz (for exact specifications, see
section "technical data").
First, check the local line voltage is in the range 100 - 240 VAC, 50/60 Hz and whether the
power plug fits your local power supply connection. If this is not the case, on no account
connect the balance or the AC adapter to the power supply, but contact the responsible
METTLER TOLEDO dealer.
Important:
●
Before operating, check all cables for damage.
●
Guide the cables so that they cannot become damaged or interfere with the weighing
process!
●
Take care that the AC adapter cannot come into contact with liquids!
●
The power plug must be always accessible.
Connect the AC adapter to the connection socket on the back of your
balance (see figure) and to the power line.
4.4.2 Battery Operation
The Balance can also operates with batteries. Under normal operation conditions, the balance works indepen
dently of the AC power line for about 8 to 15 hours (using alkaline batteries). Immediately after the AC power
supply is interrupted e.g. by withdrawing the power plug or if there is a power failure, the balance switches
automatically to battery operation. Once the AC power supply is restored, the balance reverts automatically to
AC operation.
Note: It is also possible to use rechargeable batteries. Charging batteries inside the balance is not possible.
17Setting up the Balance