Specifications

Transmitter M400/2(X)H, M400G/2XH 64

Printed in Switzerland 30 031 683

Navigate to the menu “DLI Stress Adjustment” by using the  and . keys and press [ENTER].

Adjust the Process Stress parameter based on the particular application and/or requirements

Low: DLI, TTM and ACT will be increased approximately 25% compared with “Medium”.

Medium: Default value, (equal DLI, TTM and ACT values based on former firmware versions of

the transmitter).

High: DLI, TTM and ACT will be reduced approximately 25% compared with “Medium”.

Pressing the [ENTER] key will bring up the Save Changes dialog. Selecting No will discard the

entered values, selecting Yes will make activate entered values.

8.7 Display

(PATH: Menu / Configure / Display)

Enter configuration mode as described in Section 8.1 “Enter Configuration Mode”.

This menu allows for the configuration of the values to be displayed and also the configuration

of the display itself.

8.7.1 Measurement

The display has 4 lines. Line 1 on top and Line 4 on the bottom.

Select the values (Measurement a, b, c or d) to be displayed on each line of the display.

The selection of the values for a, b, c, d needs to be done under Configuration / measure-

ment / Channel Setup.

Select the ”Error Display” mode. If this is set to ”On” when an alarm or warning has occurred,

the message ”Failure – Press ENTER” will be displayed on Line 4 when an alarm occurs in the

normal measurement mode.

Pressing the [ENTER] key again will bring up the Save Changes dialog. Selecting No will

discard the entered values, selecting Yes will make the entered values the current ones.