Specifications

Transmitter O

M300 35

M300

Printed in Switzerland 52 121 305

8.6 Alarm/Clean

(PATH: Menu/Conﬁgure/Alarm/Clea)

This Menu allows the conﬁguration of Alarm and Clean functionality.

8.6.1 Alarm

Select the Relay to be used for the Alarm.

Select either the "Power failure" or "Software failure" event to be alarmed.

If either of these is set to yes then the alarm will come on and an alarm message will be

recorded if:

1. there is a power failure or power cycling

2. the software watchdog performs a reset

The alarm indicator will be turned off when the alarm message is cleared. They will reappear

if the power is constantly cycling or if the watchdog is repeatedly resetting the system.

Conﬁgure the chosen Alarm Relay. The state can be Normal or Inverted, also a Delay for the

activation can be set.

Pressing the [ENTER] key again will bring up the Save Changes dialog. Selecting „No" will

discard the entered values, selecting „Yes" will make the entered values the current ones.