Specifications

Transmitter M300 FLOW 36
© 09 / 08 Mettler-Toledo AG, CH-8606 Greifensee, Switzerland Transmitter M300 FLOW
Printed in Switzerland 52 121 319
8.2 Measurement Setup
(PATH: Menu/Configure/Measurement)
Press [ENTER] to select Measurement Menu. The following sub menus can now be selected:
Measurements, Set Averaging, Set Pipe ID, Reset Total Flow and External Total Reset.
Press [ENTER] to select Measurements.
Select the type of sensor(s) wired to the transmitter and press [ENTER]. The options are High,
Type 2 or Low. See Section 4.5 for sensor types.
The 4 lines of the display can now be configured with a value. When configuring single channel
transmitters, pressing the [ENTER] key will display the selection for lines c and d.
Convention, Single Channel:
1
st
line on display => a
2
nd
line on display => b
3
rd
line on display => c
4
th
line on display => d
Four channel transmitters allow the configuration of both primary (A, B, C, D) and secondary
values (a, b, c, d). Press [ENTER] to display channels B through D.
C
NOTE: Pressing [ENTER] during normal Measuring mode of four channel transmitters
will toggle the display between the Primary and Secondary values.Convention,
4 Channel:
1
st
line on display => A (a)
2
nd
line on display => B (b)
3
rd
line on display => C (c)
4
th
line on display => D (d)
Pressing the [ENTER] key again will bring up the Save Changes dialog.