Specifications

Chapter 14: Appendices
Appendix 9: Junction Box Dimensions and Wiring Diagrams
(12/99) 14-21
IDNet Junction Boxes
Figure 14-13: IDNet Junction Box Dimensions
WARNING
DO NOT USE THE IDNet JUNCTION BOX IN
LOCATIONS CLASSIFIED AS HAZARDOUS BY THE
NATIONAL ELECTRICAL CODE (NEC) ARTICLE 500.
Figure 14-14: IDNet Junction Box PCB Wiring
Note: If shift adjustment is required,
engage all trimming potentiometers
by opening all eight hook latches.
Start with all eight trimming
potentiometers zeroed (turned fully
counter clockwise), Adjust both the
+Signal and -Signal trim pots for
each load cell by equal amounts.
Note: Do not cut load cell cables.
Cutting a cable will eliminate its
shield wire and affect performance.
Note: Dimensions are shown in inches.