Specifications

METTLER TOLEDO Weigh Module Systems Handbook
(12/99)11-4
3. Place the threaded rod through a hole in the upper support bracket. Fit a backing
plate and washer over the end of the threaded rod. Then double-nut the threaded
rod against the backing plate. Attach the other end of the weigh module assembly
in the same way (see Figure 11-3).
Figure 11-3: Typical Tension Weigh Module Installation
4. Install a safety rod next to each weigh module. Leave 1/8 inch clearance between
the lower support bracket and the washer on the safety rod (see Figure 11-4).
Note: Make sure that the upper and lower
clevis brackets are turned at 90 degrees
to each other. This will reduce swaying.
Upper
Support
Bracket
Lower
Support
Bracket
Safety
Rod
Threaded
Rod
Threaded
Rod