Operating instructions

3.3 Mounting the LJ16 and LP16 drying unit

Note

Before mounting, the preparatory measures must have been carried out.

LJ16, see section 3.1.

LP16, see section 3.2.

• Lift up drying cover (1).

• Take foam cushioning and plastic sheet out of draft shield (2). Remove draft shield with

packaging.

• Affix label with warning regarding heat development so that it is clearly visible.

Setting the operating voltage

• Set voltage selector (3) at rear of dryer so that the voltage matches the local power supply

voltage:

115 V (range 93 V ... 132 V)

230 V (range 187 V ... 264 V)

Mounting the dryer

•Mount dryer carefully on the balance as shown in the illustration opposite. Center hole (6) on

conical spigot of balance.

• Turn dryer clockwise until the stop.

The dryer is now mounted on the balance by means of the bayonet fixing.