Technical data

METTLER TOLEDO JAGXTREME Terminal Technical Manual
(9/00) 3-20
4. Scale ID Sub-block
The Scale ID sub-block lets you assign an identification code to a scale for use in
printing and when selecting a scale for operator viewing or interaction. The Scale ID can
be up to 8 alphanumeric characters. The default scale ID is the JAGXTREME terminal
number as determined by the Ethernet address jumpers on the Controller board and by
the internal scale designation.
1. Press ENTER at the Scale ID prompt.
2. At the ID? prompt you can either select a predefined scale identification or create a
new ID using the numeric keys to enter the scale identification label.
3. Press ENTER to continue to the next sub-block or ESCAPE to exit setup.
5. Time and Date Sub-block
This sub-block lets you set the time and date format. If you do not select a format, the
default time and date format based on the Market location will be used.
To configure the sub-block:
1. Press ENTER at the Time and Date prompt and again at Time Format?
2. At the Separator? prompt, select a character to separate hour, minutes, and
seconds:
• (:) colon
• (-) dash
• (.) period
• (sp) space
• None
3. At the Format? prompt, select the desired time format:
• 24:MM 24 hour clock, no seconds
• 24:MM:SS 24 hour clock with seconds
• 12:MM 12 hour clock, no seconds
• 12:MM:SS 12 hour clock with seconds
• None Time disabled through MEMORY key
4. Press ENTER at the Date Format? prompt.
5. At the Separator? prompt, select a character to separate month, day, and year:
• (:) colon
• (-) dash
• (.) period
• (sp) space
• (/) slash
• None
Time and Date
Time Format
Date Format
Scale ID
Enter A/N scale ID
The time format choices are given
w
ith the separator
y
ou selected in
step 2.
A Julian date is maintained by the
terminal and is available for
printing.
The date format choices are given
w
ith the separator
y
ou selected in
step 5.