Technical data

Chapter 3: Programming and Calibration
(9/00) 3-19
1. Character Set Sub-block
The Character Set sub-block lets you select a display character set appropriate for the
location where the JAGXTREME terminal is used. Depending on the character set, some
ASCII characters will be replaced with specific international characters.
To configure the sub-block:
1. Press ENTER at the Character Set prompt.
2. At the USA prompt, press SELECT to display the desired character set.
3. Press ENTER to continue to the next sub-block or ESCAPE to exit setup.
2. Language Sub-block
The Language sub-block lets you select the language in which all JAGXTREME terminal
prompts and messages are displayed.
To configure the sub-block:
1. Press ENTER at the Language prompt.
2. At the English prompt, press SELECT to display the desired language:
• English
• French
• German
• Spanish
3. Press ENTER to continue to the next sub-block or ESCAPE to exit setup.
3. Keyboard Type Sub-block
The Keyboard Type sub-block lets you select the type of alternate computer-type
keyboard (if used). It does not configure the JAGXTREME terminal keypad.
1. Press ENTER at the Keyboard Type prompt.
2. At the English prompt, press SELECT to display the desired keyboard type:
• English
• French
• German
• Spanish
3. Press ENTER to continue to the next sub-block or ESCAPE to exit setup.
Character Set
Select Character Set
Language
Select Language
Keyboard Type
Select Keyboard