Manualshelf

Technical data

ManualsBrandsMettler Toledo ManualsKitchen AppliancesID7-Base2000
71727374757677787980
Chapter 3: Programming and Calibration
Service Mode for MMR (IDNET) Bases
(9/00) 3-15
Service Mode for MMR
(IDNET) Bases
The service mode for K weighing platforms is used for:
• Input of parameters specific to the weighing platform after replacement of the
measuring cell
• Calibration of the base with the calibration weight built into the measuring cell or
externally by loading the base with the required weights
• Adjustment of linearity
• Resetting of the measuring cell parameters to the factory setting
• Clearing of a previously assigned scale number.
An MMR (IDNET) base can generate three different types of communications errors and
a general function failure indication during Service Mode operation. These types are
identified in Chapter 5. These may be cleared by pressing the ENTER or ESCAPE keys.
NATION Program Sub-block
This program sub-block allows the selection of the country of use, which sets the
certification regulations for that country. Use the SELECT key to display the various
country codes. The codes and country names are listed in the table shown below
Code Country Code Country Code Country
A Austria AS Saudi Arabia AUS Australia
B Belgium BR Brazil CDN Canada
CH Switzerland D Federal Republic of Germany DK Denmark
E Spain ET Egypt F France
FL Liechtenstein GB Great Britain GR Greece
HK Hong Kong I Italy IL Israel
IND India IRL Ireland IS Iceland
J Japan JOR Jordan KWT Kuwait
L Luxembourg MAL Malaysia MEX Mexico
N Norway NL Netherlands NZ New Zealand
P Portugal RA Argentina RC Taiwan
RCH Chile S Sweden SF Finland
SGP Singapore SUD Sudan T Thailand
TJ China USA United States YU Yugoslavia
ZA South Africa ZK South Korea
When the appropriate country code is displayed, press ENTER to accept the choice.
RESET Program Sub-block
In this program sub-block, the certification capability, maximum capacity, range and
graduation size can be reset to the factory default settings.
1. To reset the parameters to factory default, press SELECT until the display shows
Y(es).
2. Press ENTER. The display will show NO RES.