Technical data

METTLER TOLEDO JAGXTREME Terminal Technical Manual
(9/00) 3-10
If Summing is Selected
1. No other parameters are entered in this sub-block. In the capacity sub-block,
enter the total capacity of the summed scales. This value can be less than the
total capacities of the individual scales. For a legal-for-trade summed scale,
the calibration units and increment size should be identical for all scales.
2. Continue to the next sub-block or exit the setup mode.
3. Calibration Unit Sub-
block
This sub-block lets you enter the units of measure to use when calibrating the scale and
configuring capacity and increment size. Recalibration is required if you change the
calibration unit.
1. Press ENTER at the Calibration Unit prompt to open the sub-block.
2. At the Units? prompt, press SELECT until the desired calibration unit is
displayed, then press ENTER.
Calibration units include:
• Pounds
• Kilograms
• Grams
• Metric Tons
3. Choices are limited to the current settings for the primary and secondary weight
units specified in the Application Environment program block.
4. Continue to the next sub-block or press ESCAPE to exit the setup mode.
4. Capacity Sub-block
The Capacity sub-block lets you enter the maximum scale capacity. The capacity is
given in the calibration units.
1. Press ENTER at the Capacity prompt to open the sub-block.
2. At the Wgt? prompt, input the desired scale capacity using the numeric keys.
3. Press ENTER to set the capacity.
4. Continue to the next sub-block or exit the setup mode.
Capacity
Capacity Entry
Calibration Unit
Units
pounds, kg, grams,
t (metric tons)
Note: This selection is
provided only for Scale E,
the summation scale.