Technical data

Chapter 2: Installation
Seal the Enclosure - Weights and Measures Applications
(9/00) 2-31
Figure 2-p: Sealing Panel Unit
General Purpose Enclosure
1. Screw a special through-hole sealing screw into all three holes at the top of the rear
cover plate.
2. Tighten the screws and run a wire seal through the holes in the heads of the
screws.
3. Apply the lead seal.
Harsh Environment Enclosure
1. Sealing holes are located on the left and right sides of the bottom of the enclosure.
2. With the front door firmly seated on the enclosure, run a wire seal through the door
and tab holes.
3. Apply the lead seal.
4. Repeat for the opposite side.