Technical data

Chapter 2: Installation

Apply Power

(9/00) 2-27

To install JAGXTREME terminal options:

1. Disconnect all power to the terminal

CAUTION

REMOVING OR INSTALLING BOARDS WITH POWER APPLIED MAY

RESULT IN DAMAGE TO ALL CIRCUIT BOARDS. REMOVE POWER

THEN WAIT FOR AT LEAST 30 SECONDS PRIOR TO REMOVING OR

INSTALLING BOARDS.

2. Remove the rear cover of a general-purpose model by removing the four screws

securing the cover to the housing. For harsh environment enclosures, remove the

front cover as described previously in this chapter.

3. Choose the available slot where the option will be installed, then remove the blank

panel assembly by turning the two thumb screws counter-clockwise until the panel

assembly comes off.

4. Evenly align the edges of the PCB option board assembly in the grooves on each

side of the board slot and slide the board into the JAGXTREME terminal.

5. Gently press the PCB into the open slot with your hand until it is seated.

6. Turn the thumb screws clockwise to secure the panel assembly into the unit.

Tighten these with your hand; a tool is not necessary.

Apply Power

Following the connection of all external wiring, configuration of circuit board jumpers,

and installation and configuration of option boards, power may be applied to the

JAGXTREME terminal. Visually inspect the terminal to verify that these steps have been

properly carried out, and then apply power

WARNING!

VERIFY POWER, NEUTRAL, AND GROUND WIRES ARE CORRECT AT

THEIR SOURCE PRIOR TO APPLYING AC POWER. FAILURE TO DO

SO MAY RESULT IN BODILY INJURY.

On general-purpose models, power is applied by plugging the line cord into a properly

grounded AC power outlet. On panel or chassis mount models, power is applied by

turning on the AC power switch for the power distribution system.

WARNING!

AC POWER SOURCES MUST HAVE PROPER SHORT CIRCUIT AND

OVER CURRENT PROTECTION IN ACCORDANCE WITH LOCAL

AND NATIONAL ELECTRICAL REGULATIONS. FAILURE TO

PROVIDE THIS MAY RESULT IN BODILY INJURY.

It is not necessar

to use

reat force

to push the PCB into the slot.

Turning the thumb screws will help

draw the PCB into its socket.