Technical data

Chapter 2: Installation
JAGXTREME Terminal Jumper and Switch Settings
(9/00) 2-25
POWERCELL PCB
Jumpers on the POWERCELL PCB should be set as shown below:
Figure 2-q: POWERCELL PCB
*W9 is shown in the “internal” position meaning that the POWERCELL I/F PCB is using the internal power
supply to power the CMOS load cells. If the application contains more than 14 POWERCELLs, an External
Power Supply (P/N 0917-0240) must be used.
**W10 is the line termination jumper. It should be set if there is a single homerun cable with the JAGXTREME
terminal at the end of the cable.
*** W5 jumper is removed if you have two scale cards, such as an Analog Card or an MMR (IDNET) Card
and the POWERCELL Card. The W5 jumper should be installed on the MMR (IDNET) Card.
MMR (IDNET) PCB
Jumpers on the High Precision Module should be set as follows:
Figure 2-r: MMR (IDNET) PCB
W1 ON
W2 OFF
W3 = ON, W4 = OFF (Scale 1)
W3 = ON, W4 = ON (Scale 2 PCB)
W5
Analog Scale PCB - W3 Jumper in B1 Position W5 =OFF
Only Scale PCB, W5 = ON
Two IDNET PCB’s, One Set = ON, One Set = OFF
W6 17 (as shown in PCB drawing)
W7 OFF
W8 OFF
W10**
***