Technical data

Chapter 2: Installation
JAGXTREME Terminal Jumper and Switch Settings
(9/00) 2-21
JAGXTREME Terminal
Jumper and Switch
Settings
Jumper and switch settings for the Controller PCB, Analog PCB, and optional Allen-
Bradley are described in the following sections.
Controller
Jumpers and switches on the Controller PCB should be set as follows:
CAL SW Pushbutton is used when new software is downloaded to the JAGXTREME
terminal or to perform a Master Reset and to override SW 1 (below) and allow entry to
setup.
Setup SW When switch 1 of switch block SW2 is ON, then access will be denied to
Setup (also referred to as the Legal-for-Trade jumper). When SW2 is ON, the access to
test mode is enabled. This overrides a JagBASIC program that has taken control of the
keyboard and keypad.
EEPROM JagBASIC enabled
LED A Indicates that the processor is running
LED LNK indicates that the Ethernet link is established
LED T/R indicates traffic across the Ethernet link
Status Leds
EEProm
Setup SW
Figure 2-j: Controller PCB