Technical data

METTLER TOLEDO JAGXTREME Terminal Technical Manual
(9/00) 2-20
PAR 4 Discrete Output Port
Each of the eight PAR 4 outputs can be configured to announce Setpoints 1 through 12
coincidence. The 12 setpoint outputs can be configured to request either Feed or Fast
Feed, or to announce setpoint tolerance status. PAR 4 outputs can also be configured to
announce “current scale status” conditions such as:
• Net or Gross Mode
• Gross Zero
• Motion
• Over Capacity
• Under Zero
The +VOUT is jumper selectable for +5, +12, or +20 VDC. Polarity output is active at the
selected +VDC. Refer to Chapter 3 for details on configuring PAR 4 discrete outputs.
The wiring instructions for the PAR 2 discrete outputs apply to PAR 4 on the Multifunction
PCB. Please refer to the section entitled PAR 2 Output Connections for wiring details.
Keyboard and Ethernet
Connections
To make keyboard and/or Ethernet connections, refer to the drawing below and follow
these steps:
1. Remove the plugs from the back of the JAGXTREME terminal.
2. Remove the cap from the grip bushing assembly (supplied in the shipping kit that
accompanies the harsh environment and general purpose JAGXTREME terminals).
3. Route the cable end through the cap of the grip bushing.
4. Route the cable end through the grip bushing.
5. Assemble the bushing to the appropriate hole in the access cover.
6. Plug in the cable to the appropriate port (Ethernet or keyboard) on the JAGXTREME
terminal.
7. Reassemble the access cover to the JAGXTREME terminal.
8. Tighten the grip bushing cap to the grip bushing.