Technical data

METTLER TOLEDO JAGXTREME Terminal Technical Manual
(9/00) 2-4
Installing the Harsh
Environment Enclosure
Opening the Enclosure
1. Disconnect power.
2. Locate the two slots on the bottom lip of the front of the harsh environment
enclosure.
3. Gently insert the blade of a slotted screwdriver into one of the slots and press
inward (toward the enclosure). This releases a pressure tab that allows the access
panel of the enclosure to open slightly.
4. Repeat steps 2 and 3 for the other slot.
5. Remove the access panel away from the enclosure. The access panel is connected
to the Controller PCB by a cable and cannot be removed without disconnecting the
cable. You should be able to access the unit with the front panel connected.
With the access cover removed, you are now ready to make connections to the unit.
Figure 2-c describes the recommended wiring connections.
Reference Letter Suggested Cable
A Serial I/O Cables (Except DigiTOL)
PLC I/F Cabling
Ethernet Wiring
B Analog Load Cell Cabling
DigiTOL Load Cell Cabling
Figure 2-c: Harsh Environment Wiring Connections and Cable Chart
ABA