Technical data

Chapter 2: Installation

Installing the Panel Mount Model

(9/00) 2-3

Installing the Panel

Mount Model

Refer to Figure 2-b and the instructions below to install the panel mount terminal.

Figure 2-b: Panel Mount Installation Diagram

1. Cut an opening 9.58 in. (24.33 cm) × 5.12 in. (13.0 cm) to accommodate the

terminal. The tolerance for the panel cutout is ±0.06 in. (0.15 cm).

2. Using the Allen wrench included with the unit, remove the four retaining set screws

(A) located at the rear of the enclosure in the top and bottom mounting plate

grooves.

3. Remove both mounting plates (B).

4. Insert the terminal through the panel opening from the front until it is flush against

the panel. Confirm that the terminal is installed right side up.

5. Slide the top and bottom mounting plates back in the grooves and push them flush

against the panel from the back. The flared end of the plate should contact the back

of the panel.

6. Holding the unit in place, replace the four set screws and tighten until the unit is

secured and the front panel gasket is compressed.

7. Inspect the front of the JAGXTREME terminal for a good seal to the front of the

enclosure.

8. Continue to the section entitled Electrical Connections.