Technical data

Chapter 7: Service and Maintenance
Error Codes and Actions
(9/00) 7-13
Error Message Description Probable Cause Remedy
Program too big JagBASIC programming error. First problem: The pro gram
exceeds 400 text lines or
18KB.
Second problem: This error
can also occur while you are
typing in a JagBASIC
program when the temporary
program buffer becomes full.
For the first problem, separate
the program into smaller files
that can be run independently or
chained together. When
chaining, always start execution
with the largest program to
avoid memory fragmentation.
For the second problem, save
the current program and load it
in again. This will cause a
larger temporary program buffer
to be allocated.
PWC_PROTOCOL_ERR
PWC_TIMEOUT_ERR
PWC_UNDEFIND_ERR
PWC_BUFF_OVFLOW
Communication Error between
controller card and POWERCELL
card.
Bad POWERCELL card. If error persists, replace the
POWERCELL card.
PWC_CHECKSUM_ERR Checksum error on firmware on
POWERCELL card.
Bad POWERCELL card. If error persists, replace the
POWERCELL card.
PWC_EEPROM_ACCES Unable to access EE PROM on
POWERCELL card.
Bad POWERCELL card. If error persists, replace the
POWERCELL card.
PWC_EEPROM_ERR
PWC_EEPROM_CHECK
Checksum error on power scale
calibration data stored on
EEPROM on POWERCELL card.
New version of JAGXTREME
software.
Hardware failure caused
corruption of EEPROM data.
Recalibrate scale. If problem
persists, replace the
POWERCELL card.
PWC_NO_ERROR
PWC_NO_ERROR2
None. None. None.
PWC_RAM_ERR RAM memory error on
POWERCELL card.
Bad POWERCELL card. If error persists, replace the
POWERCELL card.
PWCEL_AT_NEW_ADR You attempted to readdress a
POWERCELL to a new address
that already exists on the
POWERCELL network.
Your addressing procedure
for the POWERCELLs has
created duplicate ad dresses.
Recheck your addressing
scheme. If necessary, reset all
POWERCELL addresses to the
factory default address of 240.
Begin addressing the cells
again. Use the AutoAddress
capability to minimize
addressing errors.
PWCEL_BAD_FMT The format of the data from the
remote POWERCELL is invalid.
Most likely, this is a
communication error or
power supply problem for the
re mote POWERCELLs.
Bad remote POWERCELL.
If problem persists, validate
wiring, line terminations, and
power in the POWERCELL
network. Replace the remote
POWERCELL, if necessary
PWCEL_EEP_ERR The remote POWERCELL has
reported a checksum error in its
EEPROM.
Bad remote POWERCELL. Replace remote POWERCELL.