Technical data

Chapter 3: Programming and Calibration
Maintenance
(9/00) 3-83
Maintenance Reports
1. Press ENTER to configure this sub-block. The display reads Error Report? Select
Y(es) to print the report or N(o) to not print it and move on to the next step.
2. The prompt reads Zero Report? Press Y(es) to print or N(o) to not print the
calibration management report.
3. At the Cal Mng Report? prompt, press Y(es) to print or N(o) to not print the report.
4. At the Maint Log? prompt, press Y(es) to print or N(o) to not print the maintenance
log report.
5. At the Reset? prompt, press Y(es) to reset the report log file and counters. You will
be asked to confirm your choice at the Are You Sure? prompt. Press N(o) to not
reset the report log and counters.
Network Stats
1. At the Network Stats prompt, press ENTER to configure this block.
2. At the Print Stats? prompt, press Y(es) to print the Network Statistics report or N(o)
to not print the report. Press ENTER.
Reset to Factory
1. At the Reset to Factory prompt, select Y(es) to reset this block to factory default
values.
2. You will be asked to confirm your choice at the Are You Sure? prompt. Select N(o)
to not reset this block.
Calibration
Management Report
Maintenance Log
Reset
Maintenance
Reports
Zero Report
Network Stats
Print Stats
Reset to Factory
Are You Sure
Error Report