Technical data

Chapter 3: Programming and Calibration
Clustering JAGXTREME Terminals
(9/00) 3-63
6. At the Console Log? N prompt, select Y(es) to enable session logging to the
LPRINT device. This is useful for diagnosing a PPP setup problem. Select N(o) to
disable session logging.
5. Cluster IP
Configuring the Cluster IP sub-block allows one JAGXTREME terminal to act as a
console terminal for other JAGXTREME terminals. Up to six (6) terminals can be
members of a cluster.
1. At the Net Console? N prompt, press ENTER if this terminal is not the network
console of a JAGXTREME cluster (although it might participate in a cluster for some
other network console device). Select Y(es) if this device will be the network
console for a JAGXTREME cluster.
2. At the This Term? prompt, use the numeric keys to enter a cluster ID number (1-6)
to this JAGXTREME Terminal.
3. At the Terminal #n? Y prompt, press ENTER to confirm that you are assigning one
of five (5) possible other terminals to this device as a network console. Repeat as
needed until completed with all other terminals. Select N(o) to skip this section.
4. At the IP? 111111111111n prompt, enter the IP address of the other terminal(s)
assigned to this console.
6. PC Data Access
This sub-block is used to configure up to two PCs to directly read (always) or write
(depending on the field protection and position of the Setup switch) Shared Data fields.
This access is not required to use the JAGXTREME embedded FTP Server or Web Server,
but is required for OPC Server access.
1. At the Host Node? Y prompt, select Y(es) to enable host PC #1 direct Shared Data
access. Select N(o) to disable host PC #1 and skip this section.
2. The display reads IP? 000000000000 This is the Host PC #1 IP address. Press
ENTER. Enter a specific IP address if you want.
3. Otherwise, to limit access to a specific host, enter O to allow access by any host.
7. Email
1. At the Enable Email? Y prompt, select Y(es) to enable Email Alerter, a send-only
Email client. Select N(o) to disable and skip this section.
2. If you selected Y(es), press ENTER. The display will read IP? 000000000000.
This is the IP address for the SMTP server that will forward the Email. Press ENTER.
3. The display will now read Name? prompt. Use the numeric keys to enter the name
that will be used in the Email message “Sender” field. Press ENTER.
4. At the Addr? prompt, enter the Email address to use in the Email “Sender’s Email
Address” field. The JAGXTREME terminal cannot accept return Email. However,
entering this address is useful for identifying the sending machine. Press ENTER.
5. At the Subj? Automated prompt, enter the string to use in the Email message
“Subject” field. Press ENTER.
6. At the IO Port? prompt, press ENTER to send out Email via Ethernet. Or, press
SELECT then ENTER to send Email via a dial up (PPP) serial port connection.
Cluster IP
Email