Technical data

Chapter 3: Programming and Calibration
Clustering JAGXTREME Terminals
(9/00) 3-61
Embedded Web Server
This tool provides access to the JAGXTREME terminal via an Ethernet/modem connection
using a web browser. To access it, either PPP or Ethernet access must be configured.
JAGXTREME Setup:
1. Enter setup. Select Config Network and press ENTER.
2. Select Web Server and press ENTER.
3. At the Enable Web Server prompt, select Y(es) and exit.
4. Make sure the JAGXTREME terminal has a unique IP Address and the correct
Subnet Mask.
Browser Considerations:
• Must be Internet Explorer 4.0 or higher revision.
• Disable proxy server.
• Enable cookies.
• You can specify the address to bypass the proxy for the JAGXTREME terminal. If
you are unsure about these settings, consult with your network administrator.
• To connect to the JAGXTREME terminal, type in the IP address in the URL window
and push ENTER. Example: http://146.207.105.206
• Test communications by pinging the JAGXTREME terminal. From the DOS prompt
type: PING xxx.xxx.xxx.xxx. xxx.xxx.xxx.xxx is the IP address of the terminal.
• Make sure a crossover Ethernet cable is used if you are connecting directly to the
JAGXTREME terminal.
• Always ensure the JAGXTREME terminal has a unique IP address.
1. Ethernet
This sub-block lets you configure the TCP/IP Ethernet Address options. To configure this
sub-block:
1. Press ENTER at the Configur Network prompt, then press ENTER again at the
Ethernet prompt. The display will read Adr 00e07coo1339. This is the Ethernet
MAC address entered at the factory. It cannot be modified in the field. Press ENTER.
2. At the DHCP Client? prompt, you must select N(o) to indicate that the JAGXTREME
terminal will use the permanently assigned IP address, sub mask, and gateway
address entered in the next steps. Do not select Y(es). Press ENTER.
3. The display reads IP? 111111111111. This is the permanent IP address that will
be used for the web server and for JagBASIC access to the terminal. Enter your
desired IP address and press ENTER.
4. The display reads SM? 255255255000. This is the IP address sub-mask. Enter
your desired sub-mask and press ENTER.
5. The display reads GW? 000000000000. This is the gateway IP address. Enter
your desired gateway address (if any) and press ENTER.
6. At the DNS Client? prompt, select N(o). This indicates that the JAGXTREME
terminal does not use Domain Name Server services.
Ethernet
IP? 000000000000
DHCP Client?
N(o)
SM? 255255255000
GW? 000000000000
DNS Client?
N(o)
Adr 00e07c001339