Technical data

Chapter 3: Programming and Calibration

Configure Network Program Block

(9/00) 3-51

After exiting the Configure JagBASIC program block the first time, you must use the

password each time you reenter the program block.

Please record the password and keep it in a secure location. If the password is lost, the

only way to access the JagBASIC program block again is by performing a Master Reset

which will return all JAGXTREME terminal configuration parameters to default values and

clears the RAMDISK which stores any JagBASIC programs.

Configure Network

Program Block

The JAGXTREME terminal can be configured as a network device on a local area

network (LAN). The Network Interface block lets you configure the network port and

identify which terminal nodes it may access. The following diagram describes this block:

METTLER TOLEDO recommends

that you distribute the password to

only those who need access to the

JagBASIC program block.

Configure

Network

Ethernet

Modem

Name-Password

PPP

Cluster IP

PC Data Access

Web Server

FTP Server

PLC SP Control

Reset to Factory