Technical data

METTLER TOLEDO JAGXTREME Terminal Technical Manual
(9/00) 3-50
5. Send RAM Files Sub-
block
This sub-block works with the JagBASIC send and receive programs that must be
installed in your PC and lets you configure file transfer to and from the terminal and your
PC. File transfer is initiated and transferred in setup mode.
Communications must be established between the PC and JAGXTREME terminal to
transfer files. If communications are not established, the terminal will time-out and return
to the beginning of this sub-block.
To transfer files:
1. Press ENTER at the Send RAM Files prompt.
2. At the Files to PC? prompt, select Y(es) if you want to enable file transfer from the
JAGXTREME terminal to your PC, or N(o) if you do not want file transfer in this
direction.
If Y(es) is Selected
• At the Are You Sure? prompt, select Y(es) to enable the JAGXTREME terminal
to transfer files from its RAM disk to your PC. If you respond N(o) to this
prompt, JAGXTREME terminal prompts Files From PC?
If N(o) is Selected
• At the Files From PC? prompt, select Y(es) to enable file transfer from your PC
to the JAGXTREME terminal, then respond Y(es) at the Are You Sure? prompt.
The terminal displays “Recving from PC.”
3. Press ENTER to continue to the next sub-block.
6. Initialize RAM Disk Sub-
block
This sub-block lets you delete all files in the JAGXTREME terminal’s RAM disk and
initialize it for new files.
1. Press ENTER at the Init RAM Disk? prompt.
2. At the Are You Sure? prompt, select Y(es) to delete the RAM disk files. Select N(o)
if you do not wish to erase all files on the RAM disk at this time.
3. Use caution if you select Y(es) to delete all RAM disk files. These files cannot be
recovered once they are deleted.
4. Press ENTER to continue to the next sub-block.
7. Password Maintenance
Sub-block
The Password Maintenance sub-block lets you enter a password that must be used
each time the JagBASIC program block is accessed. The password secures the
JagBASIC programs against unauthorized access and changes.
To configure the sub-block:
1. Press ENTER at the Password Maint prompt.
2. At the Passwd? prompt, enter a unique password (up to eight characters).
3. Press ENTER to accept the password and continue to the next sub-block.
Initialize RAM Disk
Are you sure?
Y/N
Send RAM Files
Enable/Disable file
transfer to/from
JAGXTREME and PC
Password
Maintenance
Enter
New Password
Refer to the JagBASIC
Programmer’s Guide for more
details.