Technical data

Chapter 3: Programming and Calibration
Configure Memory Program Block
(9/00) 3-45
7. When you have finished assigning the first setpoint, the JAGXTREME terminal
returns to the Point? prompt where you can repeat steps 2 and 3 for each
additional setpoint you wish to assign.
8. After you finish assigning all setpoints, at the Point? prompt press ESCAPE to
return to the Assign Setpoints prompt. Press ESCAPE to return to the Config
Discrete prompt. Then press SELECT to continue to the Configure Memory program
block.
Configure Memory
Program Block
This program block lets you configure literals, prompt lists, and consecutive numbers.
These items are accessed when an operator presses the MEMORY key in Normal
Operation mode. The following diagram describes the Configure Memory program block:
1. Configure Literals Sub-
block
Literals are text strings, such as site name or address, that can be printed in a template.
They can be up to 40 characters in length and are referenced by a field code (see the
Configure Template Sub-block in this chapter). You can program up to 20 literals.
To configure literals:
1. Press ENTER at the Config Literals? prompt to open the sub-block.
2. At the Literal? 0 prompt, enter a number for the literal you are creating or editing
(01-20).
3. At the Data? prompt, enter the text for the literal. You can enter up to 40
alphanumeric characters. To enter lowercase letters and characters other than
those on the JAGXTREME terminal keypad, you will need a QWERTY keyboard.
Repeat steps 2 and 3 for each literal you wish to configure.
4. Press ENTER to continue to the next sub-block or ESCAPE to exit the setup mode.
Local
!!
Configure
Memory
!!!
Configure Literals
Literal
1-20
Length Step 1-20
Loop Mode
Y
(
es
)
or No
Prompt
Starting Value
Assign Port
COM1, 2,3,4
Assign Port
COM1, 2,3,4
Node
Location
Remote
Configure Prompts
Number of Steps
Data
(
up to 40 characters
)
Clear Prompt List
Y(
es
)
or No
Configure
Consec Number
Port Location Local
or Remote
Reset to Factory
Are You Sure?
Step 1-20
Source Ke
y
bd, Serial,
Both
Starting
Value
Configure
Literals
Enter data
up to 40 characters
Literal (1-20)