Operating instructions

42 METTLER TOLEDO DE40/50/51 Density Meter
There are two ways to program a temperature compensation function, either by entering this
function directly (provided that this function is already known) or by entering a temperature
compensation table (data pairs of temperature and corresponding density). See previous
section 9.2 Result:
Case 1: Direct input of concentration function For input of temp.comp. function
Case 2: Input of concentration table For input of temp.comp. table
9.4 Decimals
This section describes how to set the decimals for your results (d, concentration).
Press the <Calc.Para> key.
Select "3.Decimals". Confirm with
<ENTER>.
Enter the number of decimals for the
density (d) respectively specific
gravity: d(t/t), d(t/4).
Enter the number of decimals for the different other options:
Conc: Concentration (must have been previously selected under Calc.Para-Result)
BRIX: Sugar concentration (must have been previously loaded with the Application
Memory Card and selected under Calc.Para-Result)
Alcohol: Ethanol concentration (must have been previously loaded with the Application
Memory Card and selected under Calc.Para-Result)
Note: The measured values will be displayed and printed out according to the selected
settings.
Calculation parameters
Method 0 < Calc.Parameter >
0.Density
1.Result
2.Temperature Compensation
3.Decimals
Method 0 < Decimals >
Density (0-5):[5]
Conc. (0-5):[5]
Brix (0-3):[3]
Alcohol (0-3):[3]
Exit :[Execute]