Operating instructions

METTLER TOLEDO DL36 11
The method
7. The method
A method with default parameters is stored in the DL36. These comprise two groups, the
measurement and result parameters, which you call up with the Titration and Result keys
and can adapt to meet the requirements of the individual determinations. You can call up the
parameters which support the method using the Setup key (see Section 8).
Notes
1. During the titration, the Titration, Result and Setup keys are locked!
2. The stirring speed is not stored as a method parameter and is also not recorded. The
stirrer is automatically activated when you start the pretitration (default value = 4).
However, you can also activate the stirrer beforehand using the Stirrer key. If you switch
off the instrument, the stirring speed you last defined remains stored.
7.1 Standard method
Group Menu Parameter Value
Titration t(stir) [s] ? 0
t(wait) [s] ? 15
t(max) [s] ? 0
Drift stop: rel ↑
rel [µg/min] ? 6
Result
Calculation ↑ Unit: µg ↑
Weight: fix ↑
Weight? 5.0000
Drift comp: off ↑
Blank? 0
Factor 1.00
Report ↑ Short ↑
Recalculation ↑ Weight ? 5.0000
Drift ? 0.00
Blank ? 0
Unit µg ↑
?: A numeric entry or confirmation of the displayed value is expected.
↑: Menus or parameters have been preset which you can select with the Select key. You
must then confirm the selection with Enter.