Operating instructions

4.2.7 Selecting peripheral device

In this menu option you can select the desired peripheral device. The balance automatically stores the

appropriate settings for every peripheral device.

Printer Attachment to a printer (e.g. METTLER TOLEDO GA42 Printer), (section 6.2).

Factory setting: bd 2400, 7b–E, HS oFF

Host Attachment to any peripheral device.

Factory setting: bd 9600, 8b–no, HS SoFt

4.2.8 Selecting data transfer mode

In this menu block you tell the balance how a value should be transferred to a peripheral device (e.g.

computer). This menu option appears only if the setting “HoSt” has been selected in the menu option

“Selecting peripheral device”.

S. oFF Data transfer mode switched off

S. Stb The next possible stable value will be transferred after triggering of the Print/Transfer command.

S. Cont All values will be automatically transferred.

4.2.9 Selecting data transfer format

With the “S. SICS” setting the data transfer formats described in MT-SICS are used. You will find the description

in the enclosed description of the operating instructions (Reference manual MT-SICS).

With the “S. PM” setting the following data transfer formats of the PM balances are used.

S. Stb: -----1.67890-g

S. Cont: S----1.67890-g

SD---1.39110-g

Note

If you wish to use other data transfer formats of the PM balances with your B-balance, please use the optional

B-M emulation software which emulates all interface commands of the PM balances (see section 6.3).

The interface is unidirectional. Incoming interface commands in the setting “S.␣ PM” are not processed further.

PrintEr

HoSt

S. oFF

S. Stb

S. Cont

S. SICS

S. PŸ≈