Operating instructions

11
Precision balances (PB-S)
➞ Have required adjustment weight ready (for certified models please refer to the notes below).
➞ Unload weighing pan
➞ Press and hold the «Cal/Menu» key down until “CAL” appears in the display, then release key. The
required adjustment weight value flashes in the display.
➞ Place adjustment weight in center of pan. The balance adjusts itself automatically.
➞ When “0.00 g” flashes, remove adjustment weight.
The adjusting is finished when the message “CAL done” appears briefly in the display, followed by
“0.00 g”. The balance is again in weighing mode and ready for operation.
AB-S and PB-S certified models
All AB-S and PB-S certified models have an internal adjustment weight and adjust themselves automatically:
AB-S: 2 times within 2 hours of connection to the power supply, thereafter periodically.
PB-S: On connection to the power supply, thereafter periodically.
For the certified AB-S and PB-S models, manual adjustment with the internal weight can also be done at a
keystroke. To obtain best possible results, it is advisable to adjust these balances regularly (for procedure, see
Adjustment Using Internal Weight).
The certified AB-S models can also be adjusted with an external weight (for procedure, see Adjustment Using
External Weight).
Because of certification legislation, the certified PB-S models cannot be adjusted with an external weight.
Notes
The adjustment procedure can be terminated at any time with the «C» key. The message “Abort” appears briefly
to confirm that adjustment has been canceled, and the balance reverts to weighing mode.
CAL
CAL donE
2000.00
------
0.00
------
0.00 g
Cal/Menu
à
à
à
à
à
à
M
E
T
T
L
E
R
T
O
L
E
D
O
F
C
a
l
/M
e
n
u
C
On
o
ff
O/T
M
E
TTLER
TO
LE
D
O
F
Cal
/M
enu
C
On
off
O/T
Cal
Cal
Cal
Cal