User's Manual

WESROC
®
RMS Industrial CTM - Operation Manual - Independent Technologies, Inc.
72-70-209, Rev. A Page 5 01/18/2017
Safety Information
Hazardous Environments
The WESROC
®
RMS Industrial Cellular Tank Monitor (CTM) is designed for safe use in environments
containing hazardous vapors. However, certain precautions need to be taken to ensure the safety of the
person(s) working with the CTM, the tank, and any associated equipment.
TO ENSURE SAFE OPERATION: Install the CTM according to the instructions contained in this CTM
Operation Manual.
WARNING!!!
Do NOT loosen or remove float gauge from a pressurized tank!
Tank decompression can cause serious injury or property damage!
WARNING!!!
Do NOT connect the CTM to any apparatus or wiring from another manufacturer!
Substitution of components may impair the intrinsic safety of the CTM!
Clean only with a damp cloth to prevent the possibility of electrostatic discharge!
Enclosure mounting bracket may contain aluminum – take care to avoid ignition hazards due to
impact or friction!
Battery Replacement
The CTM uses a replaceable, intrinsically safe battery pack. Only replace with a model MT-9100BPK-02
battery pack from Independent Technologies, Inc. Use of any other power source will compromise the
intrinsic safety of the CTM and will void the CTM warranty. Dispose of used battery pack properly.
Radio Frequency Exposure
To ensure that exposure to hazardous radio frequency radiation is prevented, the CTM must NOT be
installed in a location where humans will be routinely within 20 centimeters of the CTM.
To ensure that FCC requirements are met regarding radio frequency exposure, the CTM is NOT to be placed
in operation where it will be co-located with another CTM. Co-location is considered to be where one
operating CTM is within 20 centimeters of another operating CTM.
Compliance Information
Changes or modifications not expressly approved by the manufacturer could void the user’s authority to
operate this equipment.
This product meets the applicable FCC Part 15 rules and Industry Canada's license exempt RSSs. Operation
is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must
accept any interference, including interference that may cause undesired operation of the device.
Le présent materiel est conforme aux CNRexempts de licence d'Industrie Canada. Son fonctionnement est
soumis aux deux conditions suivantes: (1) cet appareil ne peut pas provoquer d'interférences, et (2) cet
appareil doit accepter toute interférence, y compris celles susceptibles de provoquer le fonctionnement du
dispositive.