User's Manual

Page 8

TROUBLESHOOTING

Problem Solution

Blank screen - Check that the AC adapter is properly installed, and

there is power to the outlet. When power is applied,

the Base Unit should return to the mode it was in prior

to power loss. If this is the first time power has been

applied, the Base Unit will default to the Tank Level

Display.

Blank Screen, - The auto-off feature might be active or the display

Power OK brightness may be set to the minimum level, which

could be difficult to see in daylight. Press any button

to reactivate the display. If the screen is still blank,

temporarily relocate the Base Unit to a darker location

and adjust the brightness to the appropriate level by

following the instructions provided in this guide.

COMPLIANCE INFORMATION

Changes or modifications not expressly approved by the manufacturer

could void the user’s authority to operate this equipment.

This product meets the applicable FCC Part 15 rules and Industry

Canada’s license exempt RSSs. Operation is subject to the following

two conditions: (1) this device may not cause interference, and (2) this

device must accept any interference, including interference that may

cause undesired operation of the device.

Le présent materiel est conforme aux exempts de licence

d’Industrie Canada. Son fonctionnement est soumis aux deux

conditions suivantes: (1) cet appareil ne peut pas provoquer

d’interférences, et (2) cet appareil doit accepter toute interférence,

y compris celles susceptibles de provoquer

le fonctionnement du dispositif

Ensure that 20cm (7.87in.) is maintained between the device and

your body to limit RF exposure.

[8] __________________________________________________

72-70-186-ITC Revision A