User's Manual

Page 5
o The tank level is flashing. This occurs when the tank level has
crossed a threshold specified by your service supplier. If more
than one tank has crossed its specified threshold, the Base Unit
will display a different tank level each minute. To return the Base
Unit to its normal display mode, simply press any key. Your
service provider has been notified, and they will refill your tank if
you have a “keep full” account.
Digital Clock Display and Setting
• This mode is indicated by the illumination of the clock colon in the
center of the display window, and AM, PM, or HR on the right.
• Abnormal Display Explanations
o Both the hours and minutes are displayed as dashes. This is
displayed after the Base Unit has lost power. The time will be
automatically updated when the Base Unit sends a report to the
host computer. This could be an extended period of time if the
system is working correctly, so you may want to set the time
manually.
• Setting the Time
o With the display in Time Mode, press and hold the MODE button
for approximately two seconds.
o Once the HOURS start to flash, release the MODE button and use
the UP/DOWN arrow buttons to adjust the HOURS.
o Press and release the MODE button to advance to the MINUTES
position.
o Once the MINUTES start to flash, use the UP/DOWN arrow
buttons to adjust the MINUTES.
• Enabling the Auto-Update option
o Press and release the MODE button to advance to the Auto-
Update (AUTO) option.
- Auto-Update is a feature that allows the Base Unit to
automatically set its clock when it sends a report to the host
computer. You may want to disable this feature if you have set
your Base Unit to a time different than that supplied from your
service provider.
o With AUTO displayed on the right, use the UP/DOWN arrow
buttons to select YS to enable this feature or NO to disable it.
• Setting the Time Format
o Press and release the MODE button to advance to the 12/24-Hour
Time Display option.
o With 24HR displayed on the right, use the UP/DOWN arrow
buttons to select YS to enable 24-Hour Time Display, and NO to
select 12-Hour Time Display.