User's Manual

Page 3
FEATURES
• A large, bright display that can be easily read from across the room.
The display can be adjusted to the appropriate brightness level for
various lighting conditions or an auto-off feature can be selected
which will automatically turn off the display after about 4 minutes of no
activity.
• The Base Unit’s electronics are housed in a durable enclosure, which
can be tilted to accommodate different mounting configurations. The
Base Unit can sit on a flat surface or be wall mounted.
• If your tank level reaches a predetermined level, the Base Unit will
immediately notify your propane supplier.
• With the Auto-Update (AUTO) feature enabled, you will never need to
set the time after a power failure or during daylight savings time
changes. The Base Unit will automatically set the time when it sends
your tank level to your service provider.
• The indoor and outdoor (external temperature transmitter required)
temperature can be displayed in either Fahrenheit or Celsius.
• A Transmitter Activity Indicator is included in the Base Unit. The LED
in the lower, right corner lights up when a transmitter is sending new
information to the Base Unit.
INSTALLATION of the WESROC
®
RMS DELUXE BASE UNIT
• The following are several items that will help you and your service
provider determine the best location for the Base Unit:
o Visibility: The Base Unit should be located where it is easy to
view and access.
o Power: The Base Unit requires 110V - AC to operate and should
be placed near an electrical outlet. Make sure that the AC outlet is
not connected through a switch because the Base Unit must be
plugged into constant AC power to work correctly.
o Temperature Accuracy: If you plan on using the indoor
temperature display, the Base Unit should NOT be placed in direct
sunlight, nor should it be placed near any heating or cooling source.
o Tank Location: For best results, the Base Unit should be placed
as close to the tank as possible. This may not always be possible,
but your service provider will be able to determine if the location
you have chosen will be adequate for proper operation.
• Once an acceptable location for your Base Unit has been chosen,
your service provider will complete the installation.
IMPORTANT: If you choose to relocate your Base Unit, please contact
your service provider prior to doing so. This will allow
them to ensure continued operation of your system.