User Manual

WESROC
®
RMS
Base Unit & Transmitter Installation Guide
72-70-125-ITC Rev. A © Copyright 2007, Independent Technologies, Inc. Page 11
BASE UNIT INSTALLATION (continued)
Install Base Unit
• Check that there is a WORKING telephone RJ-11 jack and 110VAC outlet in the selected Base
Unit location. A touchtone telephone is required to complete the installation, but is not necessary
for normal operation. If a customer’s telephone is to be connected through the Base Unit, ensure
that it works correctly prior to proceeding.
• Connect the LINE jack on the back of the Base Unit to the telephone wall jack, with the supplied
telephone cord.
• Connect the touchtone telephone, or craftsmen’s handset, that will be used for configuration to the
PHONE jack on the back of the Base Unit.
• Plug the AC adapter into a 110-Volt outlet and the round L-shaped power plug into the 9VDC
receptacle of the Base Unit. The Base Unit should power up and be in Tank Level Display Mode.
• Confirm that you have dial tone. Lift up the receiver of the telephone connected to the PHONE
jack on the back of the Base Unit to ensure proper operation.
Figure 4: WESROC
®
RMS Base Unit (rear view)
9VDC
JACK
LINE
JACK
PHONE
JACK