User's Manual

WESROC
®
RMS Cellular Tank Monitor - Operation Manual - Independent Technologies, Inc.
72-70-164, Rev. P4 Page 4 06/16/2011
Safety Information
Hazardous Environments
The WESROC
®
RMS Cellular Tank Monitor (CTM) is designed for safe use in environments containing
hazardous vapors. However, certain precautions need to be taken to ensure the safety of the person(s)
working with the CTM, the tank, and any associated equipment.
TO ENSURE SAFE OPERATION: Install the CTM according to the instructions contained in this
WESROC RMS Cellular Tank Monitor Operation Manual.
WARNING!!!
Do NOT loosen or remove float gauge from a pressurized tank!
Tank decompression can cause serious injury or property damage!
WARNING!!!
Do NOT connect the CTM to any apparatus or wiring from another manufacturer!
Substitution of components may impair the intrinsic safety of the CTM!
Clean only with a damp cloth to prevent the possibility of electrostatic discharge!
Enclosure mounting bracket may contain aluminum – take care to avoid ignition hazards due to
impact or friction!
Battery Replacement
The CTM uses a replaceable, intrinsically safe battery pack. Only replace with a model MT-9100BPK-02
battery pack from Independent Technologies, Inc. Use of any other power source will compromise the
intrinsic safety of the CTM and will void the CTM warranty. Dispose of used battery pack properly.
Radio Frequency Exposure
To ensure that exposure to hazardous radio frequency radiation is prevented, the CTM must NOT be
installed in a location where humans will be routinely within 20 centimeters of the CTM.
To ensure that FCC requirements are met regarding radio frequency exposure, the CTM is NOT to be
placed in operation where it will be co-located with another CTM. Co-location is considered to be where
one operating CTM is within 20 centimeters of another operating CTM.
Radio Frequency Interference
This equipment (FCC ID number RWB-MT9100CTM and IC number 115A-MT9100CTM) has been tested
and found to comply with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation.
Changes or modifications to this device not expressly approved by Independent Technologies, Inc. could
void the user’s authority to operate this device.