User's Manual

Page 4
OPERATION of the WESROC
®
RMS DELUXE BASE UNIT
Operational Overview
• The Base Unit has three pushbutton switches on the top:
o The single button on the left-hand side is the MODE button.
o The center button is the DOWN ▼ arrow.
o The right-hand button is the UP ▲ arrow.
• The MODE button toggles the display between Tank Level, Time, and
Temperature displays. The UP/DOWN arrow buttons select which
tank/transmitter is displayed.
Power Up
• When the Base Unit is first powered on, all of the display segments,
icons, and LEDs will be illuminated for about two seconds. This is
done to ensure all display components are working properly. The
Base Unit will then return to the mode that was last selected prior to
power loss.
Tank Level Display
• This mode is indicated by the illumination of a % symbol on the right
side of the display. The number on the left is the tank transmitter
number, and the number on the right is the tank level. If more than
one tank is being monitored, the UP/DOWN arrow buttons may be
used to scroll through the tank list. Your service provider has left you
a notification on the back of this guide to indicate which tank
transmitter is tied to each tank.
• Abnormal Display Explanations
o Both the tank transmitter number and level are displayed as
dashes. This indicates that no tank transmitters are initialized to
your Base Unit. Please call your service provider for proper
installation.
o The tank level is displayed as dashes. This is displayed after the
Base Unit has lost power. The level will be updated within four
hours when the Base Unit receives new information from the tank
transmitter.
o The tank level is displayed as flashing dashes. The Base Unit has
not received any new information from the tank transmitter within
the timeframe specified by your service provider. Your service
provider has been notified and they will contact you if the problem
persists.
o The tank level is displayed as a flashing NS. The tank transmitter
has detected that it has “No Sensor”. Your service provider has
automatically been notified and they will correct the problem.