User's Manual

WESROC® RMS Mini-Base Unit – User Manual
Independent Technologies, Inc.
Revision Orig. June 30, 2009 Page 8
Warranty Information
Independent Technologies, Inc. (ITC) warrants the MT9100-BM WESROC
®
RMS Mini-Base
Unit against defects in materials or workmanship for a period of one year from date of
shipment to original purchaser. All units deemed defective under this warranty will be
replaced or repaired at ITC’s option. No other warranty is expressed or implied, nor will
responsibility for operation of this device be assumed by ITC.
Radio Frequency Exposure Warning
To ensure that exposure to hazardous radio frequency radiation is prevented, this equipment
must not be installed in a location where humans will be routinely within 20 centimeters of it.
To ensure that FCC requirements are met regarding radio frequency exposure, Wesroc®
RMS Mini-Base Units are not to be placed in operation where they will be collocated with other
Wesroc® RMS Mini-Base Units. Collocation is considered to be where one operating
Wesroc® RMS Mini-Base Unit is within 20 centimeters of another operating Wesroc® RMS
Mini-Base Unit.
Radio Interference
This equipment (FCC ID number RWB-MT9100-BM and IC number 115A-MT9100-BM) has
been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the
instructions may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV technician for help.
The Wesroc® RMS Mini-Base Unit contains no user serviceable parts. Any changes or
modifications to the Wesroc® RMS Mini-Base Unit that are not expressly approved by ITC
could void authorization to use the Wesroc® RMS Mini-Base Unit.