Instructions / Assembly

INSTALLATION INSTRUCTIONS
Item #N7845-711 (04/07/2020)
READ AND SAVE THESE INSTRUCTIONS
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
Fig.1
Fig.2
Fig.3
PREPARING THE FIXTURE (Fig.2)
1. Carefully unpack the new fixture and lay out all the
parts on a clear area. Take care not to lose any parts
necessary for installation.
2. By measuring, determine the desired hanging height
and thread rods (B) into the top nipple of the fixture
body. Press the wire restraint to adjust the length of
cable (D).
3. Carefully pass the fixture wires through each rod as you
assemble.
4. Pass the wires through the loop and canopy (C) and
pull tight. Then thread the loop onto the top of rods.
MOUNTING THE FIXTURE (Fig.1)
5. Shut off the power at the fuse box or circuit breaker. If
necessary, remove the old fixture, including the
mounting hardware.
6. The mounting strap contains several pairs of threaded
holes, find the pair of holes that match the holes
spacing in your fixture canopy and thread the two
fixture screws 1/4 into the fixture mounting strap.
7. Attach mounting strap to the outlet box using the box
screws (Size: #8-32*0.5L). The side of the mounting
strap marked “GND” must face out.
8. Hook the hook of supporting cable to the mounting
strap.
CONNECTING THE WIRES (Fig. 3)
9. At this point, connect the electrical wires as shown in
Fig. 3, making sure that all wire connectors are
secured. If your outlet box has a ground wire (green or
bare copper), connect the fixture’s ground wire to it.
Otherwise, connect the fixture’s ground wire directly to
the mounting strap using the green screw provided.
After the wires are connected, tuck them carefully
inside the outlet box.
FINISHING THE INSTALLATION (Fig.1 & 2)
10. Place fixture canopy (C) over two fixture screws (or
nipple) and secure with decorative nuts.
11. Place candle cover (A) on the socket.
12. Install (5) five candelabra base bulbs up to 60 watts
each or CFL or LED equivalent (not included) in
accordance with the fixture specification—DO NOT
EXCEED THE MAXIMUM WATTAGE RATING! (NE
PAS DEPASSER LA PUISSANCE NOMINALE
MAXIMALE!).
Your installation is now complete. Return power to the
outlet box and test the fixture.
Note: Illustration on this manual is for installation
purposes only. It may or may not be identical to the
fixture purchased. Do not clean your light fixture or
parts with water or cleanser.
FIXTURE
WIRES
Black or
Smooth
H
OUSE
WIRES
Black
(Hot)
FIXTURE
WIRES
White or
Ribbed
H
OUSE
WIRES
White
(Neutral)
FIXTURE
WIRES
Bare
Copper
(Ground)
H
OUSE
WIRES
Green
(Ground)
Set A-012
-Mounting plate
-Ground screw
-Mounting screws (2)
Rod#
W35-1-687*3
W35-H-
687*1
Candle Cover#
CCV21060P-687
A
B
C
D
Outlet Box
Supply
Ground Wire
Fixture
Ground Wire
Box Screw
Canopy
Ground Screw
Decorative
Nut
Supply
Wire
Fixture
Screw
Mounting Strap
Hook