Technical Specifications

This document has been prepared in accordance with the Occupational Safety and Health Administration
OSHA Hazard Communication standard, 29 Code of Federal Regulations (CFR) 1910.1200 and American
National Standard for Hazardous Industrial Chemicals, ANSI Z400.1- 1993, Material Safety Data Sheets
.-Preparations.
auQNOITACIFITNEDI TCUDORP rry Tile
0429-11744 HO ,notnaC ,0429 xoB .O.PSSERDDA
SECTION I
,.cnI latipaC kcornorIEMAN S'RERUTCAFUNAM
ES teertS notrelliM 1021SSERDDA
Canton, Ohio
44707
EMERGENCY TELEPHONE NUMBER 330 484 4887
TELEPHONE
NUMBER FOR INFORMATION 330 484 4887
90/6/8DERAPERP ETAD
SECTION II
Tiles are predominantly fired clay.
Tiles are manufactured in various shapes, sizes and colors.
Under normal conditions these products do not release hazardous material after
installation.
HAZARD INGREDIENTS/IDENTITY INFORMATION
OSHA ACGIH NIOSH
Estimated % PEL TLV REL
3m/gm3m/gm3m/gm.tW yb.oN saCstnenopmoC suodrazaH
(8 Hr-TWA) (8 Hr-TWA)
Respirable Crystalline Silica (Quartz) 14808-60-7 20-30
10 mg/m3 * 0.05 0.05
(%SiO2 + 2)
* The OSHA PEL for respirable dusts containing 1% or greater crystalline silica varies depending
on the percentage of crystalline silica found in the air sample according to this formula.
SECTION III PHYSICAL/CHEMICAL CHARACTERISTICS
3-2 )1 = O2H( ytivarG cificepSelbacilppa toNtnioP gnilioB
elbaliava toNtnioP gnitleMelbacilppa toN)gH mm( erusserP ropaV
Vapor Density (AIR = 1) Not applicable Evaporation Rate (Butyl Acetate = 1) Not applicable
Solubility in Water Insoluble
Appearance and Odor Brittle solid, color
may vary, no odor
SECTION IV FIRE AND EXPLOSION HAZARD DATA
Flash Point (Method used) Not applicable Flammable Limits LEL Not applicable
UEL Not applicable
elbammalf non ,deriuqer enoNaideM gnihsiugnitxE
Special Fire Fighting Procedures None required
Unusual Fire and Explosion Hazards None
Material Safety Data Sheet

Summary of content (5 pages)