Installation & Assembly

INSTALLATION INSTRUCTIONS
For model#: N1754-77
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
Fig. 2
Fig. 1
FIXTURE
WIRES
Black or
Smooth
H
O
U
S
E
WIRES
Black
(Hot)
FIXTURE
WIRES
White or
Ribbed
H
O
U
S
E
WIRES
White
(Neutral)
FIXTURE
WIRES
Green or
Bare
Copper
(Ground)
H
O
U
S
E
WIRES
Green
(Ground)
Set-Mounting# A-021-370182
-Mounting plate (1)
-Green screw (1)
-Mounting screw (2)
MOUNTING THE FIXTURE, HARDWIRE (Fig. 1)
1. Carefully unpack the new fixture and lay out all the
parts on a clear area. Take care not to lose any
parts necessary for installation.
2. Shut off the power at the circuit breaker and remove
the old fixture, including the mounting hardware
2.
Position the mounting plate on the wall, and mark
location of the mounting holes, Drill the holes on
the wall, and then inserting the plastic anchors
.
3. Attach the mounting plate (B) to the junction box
(A) using the screws (N) (size:#8-32 0.5" L.).
The side of the circular strap marked “GND” must
face out, then secure the mounting plate (B)
with the wood screws（J） through the four
holes insert into the plastic anchors (I)
CONNECTING THE WIRES (Fig. 2)
4. At this point, connect the electrical wires as shown
in figure 2, making sure that all wire connectors are
secured. If your outlet has a ground wire (green or
bare copper), connect the fixture’s ground wire to it.
Otherwise, connect the fixture’s ground wire
directly to the circular strap using the green screw
provided. Tuck the wire connections neatly into the
outlet box.(
Min 90℃ Supply conductors)
COMPLETING THE INSTALLATION (Fig. 1)
5. Place fixture body over the mounting plate (B) then
secure them with screw (C) (size:
#5/32"-32*0.5"L.).
6. Take out the crystals, then fit it between lamp body
towards in the same direction, then lock it tightly
with long screws (H) and short screws(L) provided
with steel small balls (E). Remove clear plastic
washer (K) if you are having trouble securing nut to
screws.
7. Install the light bulbs (F) (not included)(4 x Max 60W
Candelabra) in accordance with the fixture’s
specifications. (DO NOT EXCEED THE MAXIMUM
WATTAGE RATING!) (NE PAS DEPASSER LA
PUISSANCE NOMINALE MAXIMALE!)
Your installation is now complete. Return power to the
outlet box and test the fixture.
NOTE: FIXTURE SHOULD BE INSTALLED BY A
QUALIFIED ELECTRICIAN TO ENSURE PROPER
WIRING AND INSTALLATION.