Operation Manual

English - 6 -
Inserting Batteries in the Remote Control
• Remove the battery cover located on the back of the remote
control by gently pulling back the indicated part.
• Insert two AAA/R3 (2 X 1.5Volt) or equivalent type batteries
inside. Place the batteries in the right direction observing the
polarity symbols (+/-) and replace the battery cover.
• While using the remote control, you should direct it
towards the front panel of the receiver. Remote range is
approximately 7m/23ft.
• If your receiver no longer responds to the remote control.
it is probable that the batteries are exhausted. If so you can
still use the local buttons of the receiver. You can replace
batteries after they are exhausted. Please only use leak
proof batteries.
Note : Remove the batteries from the remote control when
it is not being used for a long period. Otherwise it can be
damaged due to any leakage of batteries.
Connecting the Set-Top Box to a TV Set
Set-Top-Box
TV
To Scart Socket
on your TV
To HDMI Input
on your TV
You can connect your set top box to a TV by using the following methods:
1. HDMI connection: If your TV has an HDMI input, you can simply connect the set top box to your TV by
using an HDMI cable between the HDMI OUT connector on your Set-Top Box and the HDMI INPUT connector
on your TV. HDMI connection provides a better picture/sound quality.
2. SCART connection: You can also connect the set top box to your TV by using the scart socket. Use a
scart cable to connect the set-top-box to your TV.