Operation Manual

12
B - Installation of a DiSEqC 1.0 switch
If you install 2 or more dishes, or 2 LNB on the same dish, you must connect all the LNB to
a switch, featured with one single output, allowing to run one cable between the dish and
receiver (so two cables). For the installation, align each dish / each LNB just as if it was alone,
connecting directly this LNB to the receiver with one cable, without any switch. Once all the
dishes are aligned, install the switch and alter the settings of the receiver to properly drive
the switch.
Example for 2 dishes on Astra and Hotbird, Astra beeing connected to the input B of
the switch, and Hotbird beeing connected to A.
Programming
• Go to MENU / Installation menu / Antenna
installation.
• On the line Antenna, select 1 with keys 34
• On the line Satellite, if necessary, select HotBird
with keys 34
• On the line DiSEqC, select Port A with keys
34
• Select same way the satellite 2, Astra 19, on the
Port B.
• Press EXIT, confirm with OK and press two
times on EXIT to save and exit.
@ We disadvise to you formally to change the classification of the satellites.
So, please keep 1 : HotBird ; 2 : Astra 19 ...
@ You can now watch all pre-programmed channels from Astra and Hotbird.
C - Installation of two satellites
ex. Astra Hotbird
monobloc Twin
ex. Hotbird - Astra 28
AB
AB