User manual

Universal Remote Control URC 1001
English - 31
 Quit the process by pressing the EXIT button
(23) twice.
Powering All Devices On/Off
You can power on or off all devices
simultaneously. Proceed as follows:
 Press the On/Standby button (1) once.
 The remote control will send an On/Off signal
to each device. This may take up to 10
seconds.
If you have enabled the backlight, it will blink
during this process.
Deleting All Settings
You can reset all device parameters to their
factory-defaults. This will delete any codes,
macros, favourites and custom settings.
To reset the remote control, proceed as follows:
 Press and hold the SET button (21) for at least
3 seconds. The display shows [CODE SETUP].
Then release the SET button (21).
 Press
(8). The display shows
[CONFIGURE].
 Press the OK button (22). The display shows
[TIME SETUP].
 Press
(8). The display shows [RESET].
 Press the OK button (22). The backlight will
power off for a few seconds and the remote
control will restart with its default configuration.